Tools of the trade 13: Saws

Others have written whole books about saws, tooth geometry, how to use, the various advantages of different types of saws… so instead of writing a book here I’ll tell you to go read a few.

Not even with a table saw can you get away with only having one type of blade. So you need to have a few Saws in your arsenal.

P1010012P1020602

 

You need a good crosscut saw. these are for cutting stock to length.

ebaa4a55c7f6f0d74825ce3b11cd83c0

You need a good rip saw, these are for cutting stock to width.

P1020601

Now, a lot of our stock sizing is done with splitting and hewing. So maybe a ripsaw isn’t as critical as having a crosscut saw. But you will eventually find a place where you want to cut a slab of wood in the rip direction and cannot spare the waste of splitting and hewing. So when you get a Ripsaw make sure it is a good one.

For cutting tenons you will want a crosscut saw, you could use your big one for cutting stock down, but you will find that having a smaller one, perhaps with a back stiffener, to be very handy for this… these are called Back saws.

P1020603

a coping saw is handy for small stuff and some curved cuts.

P1020604

A Turning saw is good for large curved cuts.

So is a Felly saw.

and for resawing slabs to make thinner boards a big ripping frame saw or just your ripsaw can be used.

and the saw nib is just a decoration.

be well

 

 

 

Advertisements

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Google photo

You are commenting using your Google account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s